Verex Monitor ISM Especificaciones descargar pdf (Pagina 40)

36 MONITOR ISM™/AFx™ IP Connectivity Guide 22-9058 v2.1

4.3.2 Use of Remote IP Address

and Remote Port Settings

In order to initiate a call from a main panel

LCD keypad to a Director PC as described in

section 2.1.1, the IP Interface Module must

know where to call.

Start the IP Module configuration program and

establish a connection with the IP Module.

Start-up and log into Director software on the

same PC that connects with the IP module.

Obtain the Static (fixed) Remote IP address of

the PC that the Director operates on.

Quick Method:

You can view the 'Subnet Mask' and 'Default

Gateway' (and IP address of the PC) by

going to a PC on the same LAN segment as

the IP Interface board, opening a

DOS/command prompt, and typing "ipconfig".

To make sure the PC IP Address is Static

(fixed):

Go to Start / Settings / Control Panel /

Network and Dial-up Connections / Local Area

Connection / Properties / Internet Protocol

(TCP/IP). In the “General” window, “Use the

following IP address” should be checked and

indicate the PC’s IP address. This is the

Remote IP address. Make a note of what it is.

NOTE: If “Obtain an IP address automatically”

is checked instead and IP address is blank,

the PC does not have a Static IP address. It

uses a Dynamic address each time the PC

goes on line with the network. This is not

recommendable for remote dial-up because

every time the PC goes off the network and

back on again, it is assigned a random IP

address so it is always changed and would

not stay the same for the IP Interface Module

to depend on to call.

Obtain the Remote IP Port # from Director

Communications Program (Port Configuration)

as described in Sect. 2.4.1.

In the Director program, go to Account

Folders / select the desired Account /

Configuration / Panel Group / Panel / System /

Communication / Director Configuration

(Telco) / Phone number:

and type “000” (this

informs Director that it is not an external

modem calling). In the nearby Connection

type: box, select “Incoming and Outgoing IP

Calls”. Save.

Multiple IP Devices on a PC: The IP Device

must be the one referenced in the

"Communications Pool" for the "Panel Group"

associated with the specific panel connection.

See Sect: 2.4.3.

In the IP Module config program, press the

ISM tab. Under Setup, enter in the Remote IP

box the static IP address obtained from the

Director PC. In the Remote Port box, the

Remote Port # from the Director’s Port

Configuration screen. Download these new

settings to the IP Interface Module.

Now when a call is initiated from a main panel,

pressing the X key four times, followed by the

Service ID and Service User Code, the panel

will call the Director PC by way of IP and the

Director will answer.

For a panel to automatically transmit events /

alarms to the Director PC/software (Host

Reporting):

• In Panel / Configuration / System /

Communications / Host Connection – set

Reporting mode

to “256 events” and

Connection type

to Incoming and Outgoing

IP Calls.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comentarios a estos manuales

Sin comentarios