Verex Monitor ISM Especificaciones descargar pdf (Pagina 16)

12 MONITOR ISM™/AFx™ IP Connectivity Guide

22-9058 v2.1

Remote Port

(The Local Port number in the Director’s Communications Client)

Default: “0”

• This is typically 24822 but is the same as the value entered in the Director/Communications Client

(See Sect. 2.4.1, Port Configuration).

Firewall

Firewalls 1

to 5

(5 possible Firewall settings restricting the incoming data from Director to a

particular IP address or range of IP addresses)

Default: “Not Used” (selecting “Firewall” in Mode above, turns on the Firewall selection boxes)

• Not Used (Firewall inactive)

• Single IP

Enter the IP address of a particular Director Communications Client that communications

are to be restricted to.

• IP Range

Enter the range of IP addresses that you wish to restrict communications to by entering the

IP address the range begins with in the first address box and the ending address in the second

address box.

Setup

Timeout (ms) (IP communication timeout)

Default: “200”

• Leave defaulted. Do not change.

Intergap (ms) (IP communication timeout reply)

Default: “2”

• Leave defaulted. Do not change.

For any changes made, press the Send To icon on the top config screen tool bar to download

the new information to the IP module. Then press the ‘Disconnect” button after a successful

Send To.

If programming the IP board at a temporary location, you can now power it down, and deliver it for final

installation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Sin comentarios

Verex Monitor ISM Especificaciones Pagina 16