Verex Monitor ISM Especificaciones descargar pdf (Pagina 39)

22-9058 v2.1

Welcome PCPanel IP Cent. Mon. with IP

Ref. Topics

4.3 Available Security Features

It is strongly recommended that you analyze

your security requirements and implement some

of the following enhanced security options.

Note: It is best to read the descriptions below

and decide on your desired settings before

communicating with the IP Interface Module’s

program.

4.3.1 IP Interface Module Configuration

Program

Security Features Review

• Review security features mentioned previously in this document that are available with the IP

Config program.

• When selections have been decided, establish an online connection from the network PC

running the IP Config to the IP Interface Module on the same network (as described in Sect. 2.3)

to download any changes.

IP Config Security Features Programming Selections

(As presented in Section 2.3)

Setting Network Parameters, System settings, Security check boxes:

• Disable Telnet (alternative IP interface board programming utility covered in Sect. 4.5.1).

• Disable Password (free access to board program, no password restriction).

• Disable Remote Configuration (no access to board program over a WAN).

• Disable File Download (no IP board firmware upgrades).

Setting the IP Module Director Parameters

• Review Firewall options.

Setting the IP Module Security IP Receiver Parameters

•

Review Firewall options.

This section assumes that your IP

interface has already been configured

for PCPanel communications and/or

Central Monitoring with SIP. If this has

not been done yet, refer to Chapters 2

and/or 3, as applicable.

Unlike assigning the initial IP address,

security features CAN be programmed

through a WAN connection if desired.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 51 52

Sin comentarios

Verex Monitor ISM Especificaciones Pagina 39