Verex Monitor ISM Especificaciones descargar pdf (Pagina 31)

22-9058 v2.1

Welcome PCPanel IP

Cent. Mon. with IP

Ref. Topics

Bottom Half of the Screen--Rows of Settings (for each panel IP-connection):

•

Active: (  ) = Polling of this IP address

will occur (with the selected settings).

•

IP Address: The IP address of the

panel's IP interface board.

Tip: Details on

setting up the IP board appear in section

3.3.

•

IP Port: The IP port configured for the

Local Port of the IP interface board.

Typically

24833. Note: This must match the

"Local Port No." as configured for “Local Port” of

the IP interface board in the ‘SIP’ section of the IP

board Config Program.

•

Connect Mode: Choose “Auto Connect”,

“Serial Number”, “Digital Number” or “SIP

Address”.

•

Connect Number: This will either be

blank, or contain a specific number

depending on the "Connection Mode"

being used.

•

Timeout: The value in seconds the program will wait for a response to a message

from an IP Interface Module. Typically

2.0 seconds (unless you can characterize your

network connection otherwise).

•

Cycle: The poll rate for this panel in seconds. Typically every 15 seconds.

Tip: Faster poll rates get data quicker but also take up more bandwidth.

•

Retry: The maximum number of communications retries (after a “Timeout” occurs)

before considered to be a communications failure Default:

•

Description: Text field where you can enter a reference name for the panel.

•

Other: Secondary text field where more data can be entered such as an address or

reference key.

•

Account Number: This field shows you the actual account number received from the

panel so that you can track its messages into your automation software (MAS/SIMS).

You do not set this field; it is just a status field.

• State: Status field showing the current state

- Green = OK.

- Yellow = Communications trouble. X number of Retrys in progress.

- Red = Line failure after Retrys end unsuccessfully.

Buttons (lower left of IP Receiver Screen)

- “Configuration” Main screen as seen on previous page that the program defaults to

when opened.

- “Debug” Pressing this button will open a screen that will display poll and response of an

IP from the main screen experiencing trouble. Enter its IP address and port # in the

boxes supplied. Press two vertical lines to pause, right arrow to run and up arrow to

clear.

- “History” Displays ALL receiver event activities.

- “Panel Sim” Manufacturers use only.

You can only enter the configuration on a line if the

device is not active (untick the Active box, prevents

you from changing data while communicating).

You can right click and enable or disable any of

these columns.

You can also right click and select a debug column

which gives information on the number of

messages, acks, naks and a ping test in the event

that the unit appears to go down (to establish some

form of network connectivity first rather than

assume hardware failure at the panel side).

For details on

the available

"Connection

Modes", refer to

section 3.5.3

(previous).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Comentarios a estos manuales

Sin comentarios

Verex Monitor ISM Especificaciones Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Verex Monitor ISM